Theoretical study of (e,2e) triple differential cross sections of pyrimidine and tetrahydrofurfuryl alcohol molecules using multi-center distorted-wave method

We report theoretical studies of electron impact triple differential cross sections of two bio-molecules,pyrimidine and tetrahydrofurfuryl alcohol,in the coplanar asymmetric kinematic conditions with the impact energy of 250 eV and ejected electron energy of 20 eV at three scattering angles of-5°,-10°,and-15°.Present multi-center distorted-wave method well describes the experimental data,which was obtained by performing(e,2e)experiment.The calculations show that the secondary electron produced by the primary impact electron is strongly influenced by the molecular ionic multi-center potential,which must be considered when the low energy electron interacts with DNA analogues.     

On Minimal Asymptotic Bases

Mathematical Notes - Let $$\mathbb N$$ denote the set of all nonnegative integers, and let $$A\subseteq\mathbb N$$ . Let $$h,n\in\mathbb N$$ , $$h\ge 2$$ and $$r_h(A,n)=\#\{(a_1,\dots,a_h)\in...     

高压下β-InSe弹性常数、电子结构的第一性原理研究

基于密度泛函理论的第一性原理计算方法,本文研究了高压对β-InSe弹性常数、机械性能和电子结构的影响.在0～20 GPa范围内,随着压力的增大,β-InSe的晶格常数、晶胞体积逐渐减小,结构参数a/a_0、c/c_0、V/V_0单调减小.在0～12 GPa范围内,弹性模量G、E、B和泊松比v随着压力增大而增大,在16 GPa时大幅减小,G、E、B分别减小了34.9%、53.3%、82.9%.随着压力增大,Se-In和In-In原子之间的电荷密度增大,Se-In原子之间的共价键增强,层间距减小.而且,β-InSe在20 GPa时带隙消失,发生了半导体向半金属的相变.     

Lipase‐Supported Metal–Organic Framework Bioreactor Catalyzes Warfarin Synthesis

A green and sustainable strategy synthesizes clinical medicine warfarin anticoagulant by using lipase‐supported metal–organic framework (MOF) bioreactors (see scheme). These findings may be beneficial for future studies in the industrial production of chemical, pharmaceutical, and agrochemical precursors.     

Polymer nanoparticles with a sensitive CO2‐responsive hydrophilic/hydrophobic surface

Poly(methyl methacrylate) (PMMA) nanoparticles with a sensitive CO₂‐responsive hydrophilic/hydrophobic surface that confers controlled dispersion and aggregation in water were prepared by emulsion polymerization at 50 °C under CO₂ bubbling using amphiphilic diblock copolymers of 2‐dimethylaminoethyl methacrylate (DMAEMA) and N‐isopropyl acrylamide (NIPAAm) as an emulsifier. The amphiphilicity of the hydrophobic–hydrophilic diblock copolymer at 50 °C was triggered by CO₂ bubbling in water and enabled the copolymer to serve as an emulsifier. The resulting PMMA nanoparticles were spherical, approximately 100 nm in diameter and exhibited sensitive CO₂/N₂‐responsive dispersion/aggregation in water. Using copolymers with a longer PNIPAAm block length as an emulsifier resulted in smaller particles. A higher concentration of copolymer emulsifier led to particles with a stickier surface. Given its simple preparation and reversible CO₂‐triggered amphiphilic behavior, this newly developed block copolymer emulsifier offers a highly efficient route toward the fabrication of sensitive CO₂‐stimuli responsive polymeric nanoparticle dispersions. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019, 57, 2149–2156     

Comparative study on transport properties of N-, P-, and As-doped SiC nanowires: Calculated based on first principles

According to the one-dimensional quantum state distribution, carrier scattering, and fixed range hopping model, the structural stability and electron transport properties of N-, P-, and As-doped SiC nanowires(N-SiCNWs, P-SiCNWs, and As-SiCNWs) are simulated by using the first principles calculations. The results show that the lattice structure of NSiCNWs is the most stable in the lattice structures of the above three kinds of doped SiCNWs. At room temperature,for unpassivated SiCNWs, the doping effect of P and As are better than that of N. After passivation, the conductivities of all doped SiCNWs increase by approximately two orders of magnitude. The N-SiCNW has the lowest conductivity. In addition, the N-, P-, As-doped SiCNWs before and after passivation have the same conductivity–temperature characteristics,that is, above room temperature, the conductivity values of the doped SiCNWs all increase with temperature increasing.These results contribute to the electronic application of nanodevices.     

DFT mechanistic study of the H2‐assisted chain transfer copolymerization of propylene and p‐methylstyrene catalyzed by zirconocene complex

DFT computations have been performed to investigate the mechanism of H₂‐assisted chain transfer strategy to functionalize polypropylene via Zr‐catalyzed copolymerization of propylene and p‐methylstyrene (pMS). The study unveils the following: (i) propylene prefers 1,2‐insertion over 2,1‐insertion both kinetically and thermodynamically, explaining the observed 1,2‐insertion regioselectivity for propylene insertion. (ii) The 2,1‐inserion of pMS is kinetically less favorable but thermodynamically more favorable than 1,2‐insertion. The observation of 2,1‐insertion pMS at the end of polymer chain is due to thermodynamic control and that the barrier difference between the two insertion modes become smaller as the chain length becomes longer. (iii) The pMS insertion results in much higher barriers for subsequent either propylene or pMS insertion, which causes deactivation of the catalytic system. (iv) Small H₂ can react with the deactivated [Zr]?pMS?PP_n facilely, which displace functionalized pMS?PP_n chain and regenerate [Zr]? H active catalyst to continue copolymerization. The effects of counterions are also discussed. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 576–585     

Microelectromechanical Systems for Nanomechanical Testing: Electrostatic Actuation and Capacitive Sensing for High-Strain-Rate Testing

Experimental Mechanics - There have been relatively few studies on mechanical properties of nanomaterials under high strain rates, mainly due to the lack of capable nanomechanical testing devices....     

激光能量对反钙钛矿GaCMn_3薄膜结构与物性的影响

本文采用脉冲激光沉积方法在LaAlO3(001)单晶衬底上制备了反钙钛矿GaCMn3薄膜,通过控制制备过程中脉冲激光的能量,研究了不同激光能量条件对GaCMn3薄膜结构与物理性能的影响.分别利用X射线衍射仪、原子力显微镜、超导量子干涉仪和物理性能测试系统,对所制备的薄膜的晶体结构、表面形貌和磁性、电输运性质进行了研究.结果表明,制备的样品均为具有多个晶面取向的反钙钛矿薄膜,且薄膜结构和物性明显随制备激光能量的变化而变化.当激光能量为450mJ时,制备的薄膜多晶面取向性最弱,结晶性和表面形貌最优良.实验所得的薄膜均表现出顺磁-铁磁-反铁磁相转变,然而转变过程比块材较平缓,同时薄膜的电阻率并未表现出块材中的突变特征,我们推测该现象很可能是由衬底的应力及衬底的晶格膨胀对薄膜反常晶格变化的抑制作用造成的.     

Comparative absorption kinetics of seven active ingredients of Eucommia ulmoides extracts by intestinal in situ circulatory perfusion in normal and spontaneous hypertensive rats

Eucommia ulmoides Oliv. (E. ulmoides) is a valuable and nourishing medicinal herb in China that has been used in the treatment of hypertension. Given the fact that most traditional Chinese medicine is mainly used to treat disease, investigating the pharmacokinetics of traditional Chinese medicines in the pathological state is more useful than that in the normal state. However, the differences in the absorption kinetics of active ingredients of E. ulmoides extract between pathological and physiological conditions have not been reported. Therefore, in this study, the rat intestinal in situ circulatory perfusion model was used to investigate the differences in absorption kinetics of seven active ingredients of E. ulmoides extract in normal and spontaneously hypertensive rats, namely, genipinic acid, protocatechuic acid, neochlorogenic acid, chlorogenic acid, cryptochlorogenic acid, (+)-pinoresinol di-O-β-D -glucopyranoside and (+)-pinoresinol 4′-O-β-D -glucopyranoside. Our results indicate that the pathological state of spontaneous hypertension may change the absorption of active components of E. ulmoides extracts, and these findings may provide a reference for improving the rational use of E. ulmoides in the clinic.